Thingiverse
Kossel Auto hight adjusting camera Mount 20mm Extrustion
by prusanoff
9
Downloads
9
Likes
0
Makes
Hey Guys
I quickly made this for my Logitech camera that is connected to Raspberry-Pi. I always had a hard time getting a good angle on the print or a good distance so you could see the print clearly from a good vantage point.
This is made for 20X20mm extrusion to slide up and down easily with a simple push of the finger. You might want to add 1-3% to the size. I had to do some sanding after but it came out great.
You can tape glue or rubberband your camera to the arm on the side. Now
I quickly made this for my Logitech camera that is connected to Raspberry-Pi. I always had a hard time getting a good angle on the print or a good distance so you could see the print clearly from a good vantage point.
This is made for 20X20mm extrusion to slide up and down easily with a simple push of the finger. You might want to add 1-3% to the size. I had to do some sanding after but it came out great.
You can tape glue or rubberband your camera to the arm on the side. Now
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in