Thingiverse
Fast PLA temp test
by JugaadGr
108
Downloads
52
Likes
2
Makes
Gcode ready to print on Anet A8, scaled down 50% of source in order to print in almost half an hour.
STL file is same as source just scaled down 50%.
You can use the gcode as is, it worked ok on my Anet A8. Using a Gcode injector to insert the temperature steps makes it look messy in the file but it prints fine and performs temperature steps as instructed.
STL file is same as source just scaled down 50%.
You can use the gcode as is, it worked ok on my Anet A8. Using a Gcode injector to insert the temperature steps makes it look messy in the file but it prints fine and performs temperature steps as instructed.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in