Thingiverse
Solidoodle_Bulldog_XL_E3D_Carriage
by wardjr
9
Downloads
5
Likes
0
Makes
This is a mount for the BullDog XL and The E3D hot end if your utilizing the Stock Solidoodle Carriage.
Print it solid with no infill or support on its side at .3mm with a good brim. The support is built in so some clean up is required.
Most of the support will clean up well with a good razor. You will have to drill small holes for the fan screws and open the fan side of the duct.
There is no need to use the fan provided with your E3D as the Bulldog fan is ducted through and provides ade
Print it solid with no infill or support on its side at .3mm with a good brim. The support is built in so some clean up is required.
Most of the support will clean up well with a good razor. You will have to drill small holes for the fan screws and open the fan side of the duct.
There is no need to use the fan provided with your E3D as the Bulldog fan is ducted through and provides ade
Sign in to leave a comment
Sign in