Thingiverse
Clearance Remix for Adjustable Robo 3D R1+ Y axis bearing blocks
by xunker
9
Downloads
2
Likes
0
Makes
This remix gives additional clearance on the sides of the top carrier so they do not rub against the bottom of the build plate heating element. It moves the side screw mount points down by 3mm.
Also, on my printer at least, the change makes it so you can't over-tighten the top carrier. Just screw it down all the way as tight as you want, and the spacing appears to perfectly match the 8mm smooth rods (due to printer differences, your mileage may vary).
You will need to use the bottom piece
Also, on my printer at least, the change makes it so you can't over-tighten the top carrier. Just screw it down all the way as tight as you want, and the spacing appears to perfectly match the 8mm smooth rods (due to printer differences, your mileage may vary).
You will need to use the bottom piece
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in