Thingiverse
Wire chain for Sunhokey Prusa i4
by mosave
44
Downloads
39
Likes
1
Makes
This cable chain for Sunhokey Prusa i4 based on perfect A.N.Onymous link design:
https://www.thingiverse.com/thing:666118
There are few changes made in original link design.
- Link shaft was lengthened a bit for chain to be more solid.
- Small support bars were added under shaft ends for better print quality. You will need to cut off supports before assembling a chain
- First 10 of 23 links were adjusted to have stronger bending as print head in right upper position is too close to a
https://www.thingiverse.com/thing:666118
There are few changes made in original link design.
- Link shaft was lengthened a bit for chain to be more solid.
- Small support bars were added under shaft ends for better print quality. You will need to cut off supports before assembling a chain
- First 10 of 23 links were adjusted to have stronger bending as print head in right upper position is too close to a
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in