Updated Z Axis Parts for Tevo Tarantula

I removed a few of the mounting holes from the top Z-Axis bracket as is was a bit of overkill. I modified the gimble to close the snap in's to be 3.2mm holes. I had trouble finding suitable pins but found 3.2mm concrete nails at the hardware store and cut four 10mm pins from them with a hacksaw. The holes were printed a little smaller than 3.2mm but I hand reamed them with a 3.2mm or 1/4'' drill which made the pins a really snug fit.
This is the most dramatic improvement to my Tarantula, the Z