Thingiverse
POV Spinner
31
Downloads
22
Likes
2
Makes
Persistence of Vision Spinner. Inspired by Tinkernut's, I decided to make my own.
I added a channel to run the wires for power through the spinner. I just paused my print the layer before they were covered up, ran the wires and then restarted. There are 3 small tabs on each side that hold the circuit board in place. If you use the same battery holder as I did it snaps right in. The side with LEDs and ATtiny however you have to use thin wire and clip all leads or solder on the back as flush as
I added a channel to run the wires for power through the spinner. I just paused my print the layer before they were covered up, ran the wires and then restarted. There are 3 small tabs on each side that hold the circuit board in place. If you use the same battery holder as I did it snaps right in. The side with LEDs and ATtiny however you have to use thin wire and clip all leads or solder on the back as flush as
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in