Thingiverse
Cable Gland Cover M20
by Ambayonyx
126
Downloads
108
Likes
0
Makes
I had cable gland attached to an outdoor junction box, but it will take some time before I have the cable to put through it. :-(
To solve this potential water inlet, I've created this cover, which can be screwed on top. It has a M22x15 thread.
The gland I used was produced by Plieger and has EAN: 8711238245867. The first image shows the gland and original "nut".
Printing material was PLA as it is not directly in the sun.
To solve this potential water inlet, I've created this cover, which can be screwed on top. It has a M22x15 thread.
The gland I used was produced by Plieger and has EAN: 8711238245867. The first image shows the gland and original "nut".
Printing material was PLA as it is not directly in the sun.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in