Ant formicarium – 3D printable model from Thingiverse Thingiverse

Ant formicarium

6 Downloads
2 Likes
0 Makes
Download Model
A different type of Formicarium with a 1 cm (10mm) input for test tubes for moving queen from test tube set up from the start of the colonies life which can be replaced for exit to an out world.

A Sponge is required to sit in the section between the ants and the reservoir for the water. First section can then be used for food. currently there isn't a lid as i have not made one. I may also make some plugs for the opening however i normally use cotton
Source
Thingiverse
Comments
0
Makes
0

Makes

Rating

Noch keine Ratingen

Comments

No comments yet – be the first!
All Thingiverse Models More by JossSmith

Similar Models

6 Suggestions

Add to Collection