Thingiverse
Hypercube Evolution Extruder Mount 3.0
139
Downloads
64
Likes
1
Makes
First of all: Scott made an awesome job and many thanks for that.
Some points where a little bit annoying on his extruder parts and one of them was the fact, that the insert brass nuts where pulled out, when fasten them to much.
There was also some annoying leeway in the hotend fitting which let it turn unintentionally.
And last of all: I had to made some solderings to the optical endswitch, because of a plug, that doesn't fit to the original extruder mount.
So look at the photos:
I m
Some points where a little bit annoying on his extruder parts and one of them was the fact, that the insert brass nuts where pulled out, when fasten them to much.
There was also some annoying leeway in the hotend fitting which let it turn unintentionally.
And last of all: I had to made some solderings to the optical endswitch, because of a plug, that doesn't fit to the original extruder mount.
So look at the photos:
I m
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in