Thingiverse
Ball Bearing Pet Toy
by binarymein
11
Downloads
6
Likes
0
Makes
A pet toy with a steel ball bearing inside. It makes noises, and rolls around in a neat way. The ball bearings I have are 11.11mm, but anything larger will work as well.
You don't press the bearing through, you drop it inside DURING the print. Carefully set however many bearings you like into the shell while it's at 50-70% completion. Remember that the hot-end is hot and that you don't want to place the bearing until it sits below the current layer (otherwise it might collide).
With a smal
You don't press the bearing through, you drop it inside DURING the print. Carefully set however many bearings you like into the shell while it's at 50-70% completion. Remember that the hot-end is hot and that you don't want to place the bearing until it sits below the current layer (otherwise it might collide).
With a smal
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in