Thingiverse
Mansions of Madness Dash v2
by iragusa
161
Downloads
90
Likes
1
Makes
This is version 2 of my Mansions of Madness dashboard. Added some slots on the left edge to act as condition placement.
Added a lip to the character card slot to keep it from popping out. You can slide it in from the bottom edge.
Made the whole dash a bit thicker than it was originally. After printing it out the first time it was a bit thin and flimsy. But once it cooled down it was sturdy. At least it used less filament.
Also added a Mansions of Madness title below the clue holder.
Added a lip to the character card slot to keep it from popping out. You can slide it in from the bottom edge.
Made the whole dash a bit thicker than it was originally. After printing it out the first time it was a bit thin and flimsy. But once it cooled down it was sturdy. At least it used less filament.
Also added a Mansions of Madness title below the clue holder.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in