Thingiverse
RV Awning Pull Rod Clip
by RBDiggins
177
Downloads
99
Likes
0
Makes
I designed and printed a set of two of these so I could hang my Motor Home Awning Pull Rod in a compartment.
So far it has been great. I always know exactly where it is. It is a simple print, and I used a couple of 3M Command Strips to hold it on, which seems to hold great.
It slides in easy and stays put until you lift it out.
So far it has been great. I always know exactly where it is. It is a simple print, and I used a couple of 3M Command Strips to hold it on, which seems to hold great.
It slides in easy and stays put until you lift it out.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in