Thingiverse
PocketNC tool storage, height presetter, 3 jaws chuck and vice
by softbox
15
Downloads
10
Likes
0
Makes
Keep track of all your PocketNC tools and save time using the presetter.
Presetter:
Glue the clamp to caliper with epoxy.
Mount to Konus using two M5x250 threaded rod using 8 M5 nuts.
Clean konus with sandpaper to get a good contact to 3D print surface.
Reset caliper.
Set in a tool where you know the correct length.
Adjust nuts until length reading is correct.
Voilà you got a $30 tool presetter.
konus_V2 fits better some calipers.
Tool storage:
If your printer tends to warp y
Presetter:
Glue the clamp to caliper with epoxy.
Mount to Konus using two M5x250 threaded rod using 8 M5 nuts.
Clean konus with sandpaper to get a good contact to 3D print surface.
Reset caliper.
Set in a tool where you know the correct length.
Adjust nuts until length reading is correct.
Voilà you got a $30 tool presetter.
konus_V2 fits better some calipers.
Tool storage:
If your printer tends to warp y
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in