Thingiverse
Dyson V6 Attachment Wall Mount
by Keithbramley
21
Downloads
8
Likes
1
Makes
Wall mount adaptor for a Dyson V6 attachment (such as the mini mototrised tool etc)
I used supports but this could be done without perhaps if the bridge at the top of the part remains level. Print with the large flat face with the two screw holes to the print bed.
About 1mm tolerance with the Dyson attachment so should be a reasonable fit without too much play.
I used supports but this could be done without perhaps if the bridge at the top of the part remains level. Print with the large flat face with the two screw holes to the print bed.
About 1mm tolerance with the Dyson attachment so should be a reasonable fit without too much play.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in