Thingiverse

Sensor Mount cap for Customizable Bowden carriage

by Mchaos

7 Downloads

2 Likes

0 Makes

Download Model

I tried a few sensor mounts out for my Anet. Unfortunately none of them seem to be the solution. So I went back to scratch.I used the v6 clamp area from the original cap that came with the customizable bowden carriage, but the rest was ground up. This is actually the second version. The first version, which is on my printer now, is too close to the hot end fan duct, and causes it to deflect outward, which can cause an issue with leveling. It works.. but it is ugly.. so I remade it once more and

Source

Thingiverse

Comments

Makes