Thingiverse
Macbook Pro Charger Clip - Single Piece
76
Downloads
55
Likes
4
Makes
The clip broke as it got accidentally tripped on while plugged into the wall. The plastic studs broke off. Thanks to https://www.thingiverse.com/thing:627212 and https://www.thingiverse.com/make:266252. I was able to improvise and fix it.
Once you figure out how to create a small gap between the two halves/covers, it takes 5 seconds to fit the clip and slid back.
Instruction that worked me:
1. print flat with stud side down (less than 30 mins).
2. clean the support from the printed cli
Once you figure out how to create a small gap between the two halves/covers, it takes 5 seconds to fit the clip and slid back.
Instruction that worked me:
1. print flat with stud side down (less than 30 mins).
2. clean the support from the printed cli
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in