Thingiverse
Holybro 180 Pro / Runcam Split Adapter Remix
by ssayer
2
Downloads
2
Likes
0
Makes
Three things about my previous design (https://www.thingiverse.com/thing:2443900):
1. The WiFi adapter plug was too far recessed to use without an extension.
2. I wanted to not have to use a rubber band to hold/keep the balance plug away from the props.
3. Since I set my FPV channels one time and forget them, I wasn't even thinking about leaving room for the switch and the Channel LEDs.
So, in this remix, I removed some material away from the PCB spacer at the top to allow the WiFi plug to
1. The WiFi adapter plug was too far recessed to use without an extension.
2. I wanted to not have to use a rubber band to hold/keep the balance plug away from the props.
3. Since I set my FPV channels one time and forget them, I wasn't even thinking about leaving room for the switch and the Channel LEDs.
So, in this remix, I removed some material away from the PCB spacer at the top to allow the WiFi plug to
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in