Thingiverse
Z Motor Stop Anet A8.
by Wisnaeme
1
Downloads
0
Likes
0
Makes
This quickly built item is a replacement for the Z stop on the Anet A8.
It's a prototype (Working for 3 months) of a bracket that fits on the default slot for the Z Sensor. It is adjustable up and down on the slot as per the original part. The screw thread on the 18mm sensor will also allow adjustment.
The sensor should be one that can detect and respond to the casing of the left X motor. When that motor comes into range the NPN sensor should pull the Z-END sense pin low.
The only thing
It's a prototype (Working for 3 months) of a bracket that fits on the default slot for the Z Sensor. It is adjustable up and down on the slot as per the original part. The screw thread on the 18mm sensor will also allow adjustment.
The sensor should be one that can detect and respond to the casing of the left X motor. When that motor comes into range the NPN sensor should pull the Z-END sense pin low.
The only thing
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in