Thingiverse
Onewheel+ Bumper
by ianjohnson
45
Downloads
35
Likes
0
Makes
A bumper for the Onewheel+. This will also work with a V1 Onewheel which would make it possible to use OW+ footpads on a V1. There is also a version for TPU which is has been thickened in some areas to keep them from being too flexible.
Use #10-32 heat inserts in the holes on the inside where the screws from the top of the rail go in- https://www.mcmaster.com/#93365a154/=18m8lbu
If you are using S3D, it may not generate support everywhere it needs. Use the support tool and make sure the
Use #10-32 heat inserts in the holes on the inside where the screws from the top of the rail go in- https://www.mcmaster.com/#93365a154/=18m8lbu
If you are using S3D, it may not generate support everywhere it needs. Use the support tool and make sure the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in