Thingiverse
Printrbot Smalls (LE, Limited Edition) Spool Holder
by Saf
6
Downloads
1
Likes
0
Makes
# Printrbot Smalls LE Spool Holder
*May work on Printrbot Smalls Standard Edition as well*
An angled spool holder to hold spools up to ~95mm wide.
Gravity keeps spools in place (held against the angled base of the holder) while printing.
Install next to the handle where the spool holder points upward.
Your spool of filament should rest against the holder base and angle away from and over the printer Y-carriage metal arm.
Holds Minimum Spool Diameter of ~30mm.
Attaches using tw
*May work on Printrbot Smalls Standard Edition as well*
An angled spool holder to hold spools up to ~95mm wide.
Gravity keeps spools in place (held against the angled base of the holder) while printing.
Install next to the handle where the spool holder points upward.
Your spool of filament should rest against the holder base and angle away from and over the printer Y-carriage metal arm.
Holds Minimum Spool Diameter of ~30mm.
Attaches using tw
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in