Thingiverse
Guided Spool Stand
by Cynr1c
28
Downloads
14
Likes
0
Makes
Simple compact spool stand using 608 ball bearings.
Required 2 parts and bearings per side of the spool (so 4 in total).
Clean out the holes in the large cylinders, sand/file both cylinders until they are nice and round if necessary. Push the bearings onto the larger cylinders, press them all the way down, place 2 assemblies onto each other and press them together gently but firmly. Repeat for the other side.
Filament should be pulled from a low position.
This stand differs a little fro
Required 2 parts and bearings per side of the spool (so 4 in total).
Clean out the holes in the large cylinders, sand/file both cylinders until they are nice and round if necessary. Push the bearings onto the larger cylinders, press them all the way down, place 2 assemblies onto each other and press them together gently but firmly. Repeat for the other side.
Filament should be pulled from a low position.
This stand differs a little fro
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in