Anet A8 J-Head compatible mount (supports E3D v5/v6 etc) UPDATED

DISCLAIMER: I haven't actually attached this to my printer as I'm waiting for some fittings for the rest of the bowden setup, however there's nothing that I see that could be an issue.

I've installed it into my printer and realised that it triggers the end stop 12.5mm before it should so I would use the G28 (to home) and then M206 command to see what your current offsets are if there are any say your offset is X-40 Y-20 Z0 Then I would change it to X-24

My settings are X-14 Y-20 Z0.