Thingiverse
MOSER Genio hair clipper attachment 20-25mm
by kishoderrek
14
Downloads
28
Likes
0
Makes
My design of the attachment for the *MOSER Genio* hair clipper. Factory attachments has 3/6 and 9/12mm size, and I tried to make it bigger - *20/25mm*. And here is the result.
And it was tested (on my beard) - work fine, but of course not so good as shorter attachments.
It took like 2 hours in the Fusion 360 to design, 10 hours to print (the first prototype print took 16 hours), and near 30 minutes to remove the supports and do a little sanding ;)
Sliced with the Simplify3d 4.0.0 (singl
And it was tested (on my beard) - work fine, but of course not so good as shorter attachments.
It took like 2 hours in the Fusion 360 to design, 10 hours to print (the first prototype print took 16 hours), and near 30 minutes to remove the supports and do a little sanding ;)
Sliced with the Simplify3d 4.0.0 (singl
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in