Thingiverse
REBEL Spinner
by TominoCZ
2
Downloads
2
Likes
0
Makes
This is my own design.. I was bored..
This spinner is made for a 16 mm bearing in diameter. The width of the nuts used is 12.7 mm or 0.5 inches. The whole spinner is about 7.5 cm in diameter.
That 3D visualization is a part of a program that i released a while ago in case you're wondering.. the program is called Multi-Filamentier. It basically inserts the command "M600" to a desired height.
The command M600 pauses the print for a filament change.
Oh and the program also features AutoUp
This spinner is made for a 16 mm bearing in diameter. The width of the nuts used is 12.7 mm or 0.5 inches. The whole spinner is about 7.5 cm in diameter.
That 3D visualization is a part of a program that i released a while ago in case you're wondering.. the program is called Multi-Filamentier. It basically inserts the command "M600" to a desired height.
The command M600 pauses the print for a filament change.
Oh and the program also features AutoUp
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in