Thingiverse
Basic Rapberry Pi Case
by NirDobovizki
32
Downloads
25
Likes
0
Makes
This is a basic Raspberry Pi case, designed for the Raspberry Pi 2 but should also fit the 3 and B+
The case has access to all the Pi's external ports and the SD card, there's a decorative hole in the lid (no fan) that can help a bit with cooling or be a place to pass wires to the Pi's GPIO headers.
There are for pins in the bottom part that fit the Pi's mounting holes and hold the lid in place - the Pi should slide in without using force, but any extra plastic left in the case (especially on the pins) can interfere and should be cleaned up, the case walls are thicker in areas that are likely to break.
Printed in PLA, 100% infill
I made this model just to learn fusion 360, this is the first model I created and printed with this software.
The case has access to all the Pi's external ports and the SD card, there's a decorative hole in the lid (no fan) that can help a bit with cooling or be a place to pass wires to the Pi's GPIO headers.
There are for pins in the bottom part that fit the Pi's mounting holes and hold the lid in place - the Pi should slide in without using force, but any extra plastic left in the case (especially on the pins) can interfere and should be cleaned up, the case walls are thicker in areas that are likely to break.
Printed in PLA, 100% infill
I made this model just to learn fusion 360, this is the first model I created and printed with this software.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
