Thingiverse
3D Printer Proximity Sensor Component Box
by neildonn
4
Downloads
3
Likes
0
Makes
After following Thomas Sanladerers (https://www.youtube.com/watch?v=EcGFLwj0pnA&t=610s) instructions how to use and wire an Inductive Proximity Switch LJ12A3-4-Z/BY Sensor Detection PNP to a RAMPS board I decided to create a box/case for the components.
As you can clearly see the two resistors (15k - left and 10k - right, are used). Please follow Toms instructions for wiring. You will need 6 m3 6mm bolts. Four inside and four outside.
As you can clearly see the two resistors (15k - left and 10k - right, are used). Please follow Toms instructions for wiring. You will need 6 m3 6mm bolts. Four inside and four outside.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in