Thingiverse
Koni Strut Adjuster Rotor Grip Rx7
by B_Jiggy
4
Downloads
5
Likes
0
Makes
[UPDATE 8/5/17]
The second one I printed had some deformation of the slot which prevented proper alignment when sliding over the adjuster. Make sure you have a minimum layer time set to slow it down at the top shaft portion so it doesn't get progressively hotter and distort at the top of the print.
------------
I printed this using Taulman3D Alloy 910 nylon filament at 75% infill and a low low temp of 228C according to Cura and my Printrbot Simple Metal. Temp is rated from 240C so I'm kin
The second one I printed had some deformation of the slot which prevented proper alignment when sliding over the adjuster. Make sure you have a minimum layer time set to slow it down at the top shaft portion so it doesn't get progressively hotter and distort at the top of the print.
------------
I printed this using Taulman3D Alloy 910 nylon filament at 75% infill and a low low temp of 228C according to Cura and my Printrbot Simple Metal. Temp is rated from 240C so I'm kin
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in