Thingiverse
40mm Fan Duct for E3D V6 clone on Kossel
by NilsR
14
Downloads
6
Likes
0
Makes
SUPERSEDED BY https://www.thingiverse.com/thing:2807481
Simple fan duct for a 40mm fan to just clip onto an E3D V6 clone (23mm diameter).
I didn't find any fan ducts for my Kossel printer that fit with the Jojak E3D V6 effector, so I made my own.
Can be printed entirely without cooling if you use supports and brim.
The one in the photo is the short version. Sorry for the snotty nozzle, it has leaked a bit and I haven't been able to clean it properly yet.
Simple fan duct for a 40mm fan to just clip onto an E3D V6 clone (23mm diameter).
I didn't find any fan ducts for my Kossel printer that fit with the Jojak E3D V6 effector, so I made my own.
Can be printed entirely without cooling if you use supports and brim.
The one in the photo is the short version. Sorry for the snotty nozzle, it has leaked a bit and I haven't been able to clean it properly yet.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in