Thingiverse
Tesla Coil Primary
by ldm314
80
Downloads
66
Likes
0
Makes
Tesla coil end cap and primary form. Made for coils wound on 4.5" OD pipe. Use with 1/4" copper pipe. Distance between coil centers is 0.68" (17.35mm).
Top load form for same pipe: https://www.thingiverse.com/thing:2472952
Update: This model is a little undersized. It fit but was very tight. It turns out to be 4.25 diameter instead of 4.5. Didn't stop it from working thought!
It is controlled with a wemos microcontroller running nodemcu lua, using a modified inductive heater circuit for
Top load form for same pipe: https://www.thingiverse.com/thing:2472952
Update: This model is a little undersized. It fit but was very tight. It turns out to be 4.25 diameter instead of 4.5. Didn't stop it from working thought!
It is controlled with a wemos microcontroller running nodemcu lua, using a modified inductive heater circuit for
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in