Thingiverse
Prusa i3 MK2 Dual Fan Duct
by gustofusion
428
Downloads
206
Likes
4
Makes
More available at http://prusamk2.com
Made for the Prusa i3 mk2. Blasts the air on each side of your print, preventing part curling and greatly increase the ability to print more extreme overhangs and improved bridging.
Print in petg, abs or PC. Pre sliced gcode for petg included.
Support is built in for the lower Mount hole. Trim off after print completes.
Duct should be mounted with the mount plate behind the parts blower fan then secured in place with screws.
Note: Works with a E3D S
Made for the Prusa i3 mk2. Blasts the air on each side of your print, preventing part curling and greatly increase the ability to print more extreme overhangs and improved bridging.
Print in petg, abs or PC. Pre sliced gcode for petg included.
Support is built in for the lower Mount hole. Trim off after print completes.
Duct should be mounted with the mount plate behind the parts blower fan then secured in place with screws.
Note: Works with a E3D S
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in