Thingiverse
FT5 E3D Titan Aero Cooling duct
by Garrett_w
75
Downloads
36
Likes
0
Makes
Designed for the Folgertech FT-5 with the E3D Titan Aero.
This has been tested and it was a tight fit but everything lined up on a friends machine. I have been told by 1 other person that not all of it lined up on their machine so print with caution.
I do plan to have a v2 version of this out soon so you could just wait for that.
To install this run bolts through the 2 counter sunk holes and into the holes on the factory carriage. the last mounting hole is for a bolt that goes through t
This has been tested and it was a tight fit but everything lined up on a friends machine. I have been told by 1 other person that not all of it lined up on their machine so print with caution.
I do plan to have a v2 version of this out soon so you could just wait for that.
To install this run bolts through the 2 counter sunk holes and into the holes on the factory carriage. the last mounting hole is for a bolt that goes through t
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in