Thingiverse
17mm Hex Hub for 6mm shaft motor.
by MettaUK
26
Downloads
34
Likes
0
Makes
Wanted to reduce weight from using brass/steel hubs, so printed a beefed up ASA version for 6mm shaft motors on a low speed robotics project.
Printed in ABS/ASA at 100% fill to maximise strength.
Holes for M3 grub screws and M4 wheel bolt will require tapping or a little force to get screws to tap themselves.
6mm Shaft and 17mm hex end should be a tight fit. If to tight maybe under size by a small margin, or reduce over extrusion to get a good fit.
If you like or use this please send
Printed in ABS/ASA at 100% fill to maximise strength.
Holes for M3 grub screws and M4 wheel bolt will require tapping or a little force to get screws to tap themselves.
6mm Shaft and 17mm hex end should be a tight fit. If to tight maybe under size by a small margin, or reduce over extrusion to get a good fit.
If you like or use this please send
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in