Jhead Adapter for the Tito Direct Drive Extruder

An adapter for the Tito Direct drive Extruder. http://www.thingiverse.com/thing:110269. It has been remade to fit a Jhead, but I needed the extra clearance as I am mounting two of these face to face on my Prusa V2. The clearance is needed for the belt.

I did have to drill out my x carriage to match this hole pattern and allow for two hot ends to be put back to back.

The issues I have seen with mounting these in this manner are:
* It is hard to feed the filament in during a changeout. I