24volt - USB power supply - version 3

I revised my original design to use different terminals. Everything else is the same

This is an enclosure for a 6-24 volt inverter that you can use to power a PI or other USB powered device. You can use this to power your OctoPrint from your 3d printer power supply

You will need:

HiLetgo 5pcs DC-DC Buck Step Down Module 6-24V 12V/24V to 5V 3A USB Charger Module Arduino
https://www.amazon.com/gp/product/B01HXU1C6U

and a

uxcell 220V 2 Position H Type Screw Terminal Blocks Strips Wire Cable Connector
https://www.amazon.com/uxcell-Position-Terminal-Blocks-Connectors/dp/B01MYCGMQO