Thingiverse
250 Printable Quadcopter
von gjt211
15
Downloads
15
Likes
0
Makes
Simple 250 quad copter (multirotor).
Print four arms and one of each other piece.
I have used 2216 motors and 9x4.7 props with a 4S 2200mAh battery. Have not pushed it too hard yet, but it flies. I recommend the arms be printed in ABS as it can handle the motor temperature as they warm up during use. The othre parts could be made from PLA or ABS.
There are holes and spaces within the parts to allow for a neat and tidy assembly with little wiring visible.
Comments and suggestions welcome.
Print four arms and one of each other piece.
I have used 2216 motors and 9x4.7 props with a 4S 2200mAh battery. Have not pushed it too hard yet, but it flies. I recommend the arms be printed in ABS as it can handle the motor temperature as they warm up during use. The othre parts could be made from PLA or ABS.
There are holes and spaces within the parts to allow for a neat and tidy assembly with little wiring visible.
Comments and suggestions welcome.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
