Thingiverse
250mm HO Turntable
door rkarns
10
Downloads
6
Likes
0
Makes
This is a 250mm HO turntable designed for smaller printers. It uses the max working area of my Anycubic Vyper.
From the original design, use the code, all the pieces of the shack, motor holder, motor gear and center sleeve.
Print 2x short railings.
Print 2x fascia.
Print 4x wheel and wheel support
Use the alignment jig to locate the wheel supports. The exact position isn't critical as they are radial to the center.
All design done in Fusion360. Parts should be able to be uploaded and modified if needed.
From the original design, use the code, all the pieces of the shack, motor holder, motor gear and center sleeve.
Print 2x short railings.
Print 2x fascia.
Print 4x wheel and wheel support
Use the alignment jig to locate the wheel supports. The exact position isn't critical as they are radial to the center.
All design done in Fusion360. Parts should be able to be uploaded and modified if needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!