Thingiverse
Prusa MMU - Right Angle Extruder Bracket
by B_Dubb42
13
Downloads
3
Likes
0
Makes
A bracket for the Prusa "MultiMaterial Upgrade", allowing the extruders to be perpendicular to the top frame.
This is helpful if an enclosure is being used (i.e. IKEA Lack, cabinet, etc...), and there isn't much headroom for the PTFE tubes to angle upwards. The PTFE tubes just barely come over the top of the frame.
Extruder frame is 24mm (~1") above the frame
PTFE tubes are ~1mm above the frame
WARNING: The extruder frame is rotated with the motors facing down, this causes the extruder
This is helpful if an enclosure is being used (i.e. IKEA Lack, cabinet, etc...), and there isn't much headroom for the PTFE tubes to angle upwards. The PTFE tubes just barely come over the top of the frame.
Extruder frame is 24mm (~1") above the frame
PTFE tubes are ~1mm above the frame
WARNING: The extruder frame is rotated with the motors facing down, this causes the extruder
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in