Teutonia BeYou KiddyBoard clip

This strange looking piece is actually used to lift the KiddyBoard of a Teutonia BeYou stroller up in the air.
The font piece clips into a gap at the end of the baord. The big piece on the back has to little slots to fiddle a pice of belt through, This is finally applied to the footrest of the stroller and you are done.

Try to print this in PETG, ABS or some other non-PLA stuff (Nylon, Colorfabb XT).
PLA is too brittle for this. I had great durable results with Colorfabb XT.