Thingiverse
Martian II Antenna Mount for TBS Unify
by Daubut
63
Downloads
53
Likes
0
Makes
Antenna mount for TBS unify pro on Martian II rear standoffs! No screws necessary just wiggle the plugs thru the holes, it takes some wiggling but it fits perfect. Flexible out of TPU allows antenna to give in a crash and not break. works awesome!
TIP: - This design is for some knurled standoffs I was using. I later realized they were a little larger than average stand offs. If you use a few wraps of electrical tape cut down to the width wrapped around the stand off, and they will fit snug if
TIP: - This design is for some knurled standoffs I was using. I later realized they were a little larger than average stand offs. If you use a few wraps of electrical tape cut down to the width wrapped around the stand off, and they will fit snug if
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in