Thingiverse
Creality CR-10 Z Shaft Housing V.2
by Double_Alfa
59
Downloads
36
Likes
0
Makes
[PLEASE NOTE THAT THIS PART IS MADE FOR THE OLD CR-10 PRINTER]
Based on the request of AppyUX, a Thingiverse member, I made this full CR-10 Z shaft housing to replace the stock part that caused the shaft to wobble.
As shown in an attached photo, the stock part shaft hole was made oval and not circle, causing the shaft to wobble accordingly.
The previous version 1, the cap only, will also work fine if you'd prefer a simple fix.
Based on the request of AppyUX, a Thingiverse member, I made this full CR-10 Z shaft housing to replace the stock part that caused the shaft to wobble.
As shown in an attached photo, the stock part shaft hole was made oval and not circle, causing the shaft to wobble accordingly.
The previous version 1, the cap only, will also work fine if you'd prefer a simple fix.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in