Thingiverse
Minimalistic easy-to-print 48T chainguard
by brainwash
9
Downloads
6
Likes
0
Makes
This is an easy-to-print chainguard for a chainring that does not accept a guard. I have no idea what brand the chainring is, but it has 48 teeth.
I guess you can use it on smaller chainrings as well, it's meant to be fastened with zip-ties.
**Instructions:**
Printed in PLA at 205C, 20% infill. Print with the flat side down for a nice adhesion, drafted side down for easy removal. It requires a minimum of 200mm x 100mm printing surface. You would probably need to print two copies. No support
I guess you can use it on smaller chainrings as well, it's meant to be fastened with zip-ties.
**Instructions:**
Printed in PLA at 205C, 20% infill. Print with the flat side down for a nice adhesion, drafted side down for easy removal. It requires a minimum of 200mm x 100mm printing surface. You would probably need to print two copies. No support
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in