Thingiverse
Direct Drive
by Troldtoft
9
Downloads
4
Likes
0
Makes
I designed this direct drive, hot-end, radial fan and z-induction sensor holder to better print flexible materials. As a side note I also installed a special cable system for my Prusa i3 Steel which can be added (I will attach a link later on).
The holder is made for E3Dv6.
1. Can be used with nema17 42 mm or smaller
2. All marks for nuts are designed for M3, but are a bit too small. The reason is that the nut should be heated and pressed into the prepared hole. This embeds the nut withou
The holder is made for E3Dv6.
1. Can be used with nema17 42 mm or smaller
2. All marks for nuts are designed for M3, but are a bit too small. The reason is that the nut should be heated and pressed into the prepared hole. This embeds the nut withou
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in