Thingiverse
Simple display bracket - no extra mounting hardware needed
by mjmnz
2
Downloads
0
Likes
0
Makes
A simple display bracket that slides onto the brass standoffs between the front and back perspex panels.
The bracket can be folded out of the way when you want to hold the display or put it on the desk. To fit to the top frame, rotate the brackets so they point down and slide it over the top 2020 frame. Display is at 10 degrees off vertical.
No additional screws or bolts. 2.63 m of 1.75 mm filament. Weighs approximately 7 gms.
You will need two.
The bracket can be folded out of the way when you want to hold the display or put it on the desk. To fit to the top frame, rotate the brackets so they point down and slide it over the top 2020 frame. Display is at 10 degrees off vertical.
No additional screws or bolts. 2.63 m of 1.75 mm filament. Weighs approximately 7 gms.
You will need two.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in