Thingiverse
Duckietown Duckiebot Motor Mount
7
Downloads
3
Likes
0
Makes
This is a motor mount for robots described in: http://duckietown.org
The purpose of this part, is to mount the plastic motors to the DAGU chassis. The original motor mounting method is by means of using 4 red little plastic pieces that hang from the top and the motors are squeezed with screws. We observed this caused problems:
a. after wheel calibration is done, and the robot is used for a while, the calibrations will change, because the motor mount will move.
b. by using screws to moun
The purpose of this part, is to mount the plastic motors to the DAGU chassis. The original motor mounting method is by means of using 4 red little plastic pieces that hang from the top and the motors are squeezed with screws. We observed this caused problems:
a. after wheel calibration is done, and the robot is used for a while, the calibrations will change, because the motor mount will move.
b. by using screws to moun
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in