Thingiverse
Spektrum DX6i Trim Lever
by steve_tronic
13
Downloads
10
Likes
1
Makes
Based on the design of user domestic hacks - redrawn and added some ripple/grip on top - so slightly improved.
Replacement part for the trim levers of the Spektrum DX6i RC-remote-control. This part often gets broken.
The two wings are more stable than on the original lever, thus it's unlikely to get broken again.
To mount it: use a 3mm screw or even better a 3mm threaded rod and cut off a piece that fits.
For 3d printing. Works fine =)
I hope this remix is ok, otherwise contact
Replacement part for the trim levers of the Spektrum DX6i RC-remote-control. This part often gets broken.
The two wings are more stable than on the original lever, thus it's unlikely to get broken again.
To mount it: use a 3mm screw or even better a 3mm threaded rod and cut off a piece that fits.
For 3d printing. Works fine =)
I hope this remix is ok, otherwise contact
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in