Thingiverse
Davinci - E3D Custom Carriage
by gobygoby
11
Downloads
8
Likes
0
Makes
Custom carriage for E3D hotend and Davinci XYZ designed to be used with hardened steel rods and SC8UU bearings.
Features:
- The hotend can easily be swapped out. (for example, when I print in nylon I use 3mm while everything else is 1.75mm)
- There is room under the carriage for many of the preexisting E3D fan ducts.
- The spacers can be used to raise the carriage if needed. Otherwise make sure to use one of these to adjust the z-axis height: https://www.thingiverse.com/thing:621440
Features:
- The hotend can easily be swapped out. (for example, when I print in nylon I use 3mm while everything else is 1.75mm)
- There is room under the carriage for many of the preexisting E3D fan ducts.
- The spacers can be used to raise the carriage if needed. Otherwise make sure to use one of these to adjust the z-axis height: https://www.thingiverse.com/thing:621440
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in