Thingiverse
Prusa i3 MK2S No Mod Cable Chain Kit - Remix (longer) X Axis Mount
by spid303
8
Downloads
6
Likes
0
Makes
I'm was using parts as this X-axis mount https://www.thingiverse.com/thing:2311596
but not the same Rambo case (chain coming out on the other/right side of the USB connection) and the cable chain required the longer mount but it is a bit to long and also sometimes touches the Rambo case when printing to close to the edge.
Then I found the remix i remixed this from https://www.thingiverse.com/thing:2496035 but it's to short so I remixed the two to create a longer version that is about one ca
but not the same Rambo case (chain coming out on the other/right side of the USB connection) and the cable chain required the longer mount but it is a bit to long and also sometimes touches the Rambo case when printing to close to the edge.
Then I found the remix i remixed this from https://www.thingiverse.com/thing:2496035 but it's to short so I remixed the two to create a longer version that is about one ca
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in