Thingiverse
MRM 180 camera bracket
by GRay_111111
4
Downloads
0
Likes
0
Makes
UPDATED V3
clearance for props increased.
For MRM 180 frames
Print in TPU (will work in PLA ABS etc )
not tested as yet but should be fine for HS1177 Foxeer Monster etc.
May need a washer or two between camera and mount for some cameras.
(28.5mm wide camera?)
work in progress - so apply a little caution.!
clearance for props increased.
For MRM 180 frames
Print in TPU (will work in PLA ABS etc )
not tested as yet but should be fine for HS1177 Foxeer Monster etc.
May need a washer or two between camera and mount for some cameras.
(28.5mm wide camera?)
work in progress - so apply a little caution.!
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in