Thingiverse
Raspberry Pi Snap together case with 40mm fan mount
by kwh32901
23
Downloads
11
Likes
0
Makes
** 10/07/2017 Enlarged pass thru hole for fan wires **
Snap together case with support for a 40mm fan for a Raspberry Pi B+,2,3. The Raspberry Pi screws into the bottom with 6mm m3 screws.
There is a hole to feed the power wires through, and a snap out for access to the remaining GPIO (general purpose input/output) pins.
Opening for SD card provides easy access.
There is a Pegboard mount for this case available here: https://www.thingiverse.com/thing:2509055
These stick on feet
Snap together case with support for a 40mm fan for a Raspberry Pi B+,2,3. The Raspberry Pi screws into the bottom with 6mm m3 screws.
There is a hole to feed the power wires through, and a snap out for access to the remaining GPIO (general purpose input/output) pins.
Opening for SD card provides easy access.
There is a Pegboard mount for this case available here: https://www.thingiverse.com/thing:2509055
These stick on feet
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in